Full Description

1.1This practice describes procedures to be followed during alternating current field measurement examination of welds for baseline and service-induced surface breaking discontinuities.

1.2This practice is intended for use on welds in any metallic material.

1.3This practice does not establish weld acceptance criteria.

1.4Units-The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system might not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Product Details

Published: 11/01/2012 Number of Pages: 15File Size: 1 file , 170 KBRedline File Size:2files, 400 KB