Cart
0
Product
Products
(empty)
No products
To be determined
Shipping
$0.00
Total
Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart.
There is 1 item in your cart.
Total products
Total shipping
To be determined
Total
Sale!
View larger
View larger
More info
Description / Abstract:
Introduction
Note: Nothing in this standard supercedes applicable laws and regulations.
Note: In the event of conflict between the English and domestic language, the English language shall take precedence.
Purpose. The purpose of this test is to determine how the design of clean air ducts (low pressure side for turbocharger) will react to changes in vacuum caused by slow/steady engine vacuum increase, and sudden/short term vehicle acceleration with a dirty air filter. The test determines a change in the cross section profile of the duct at the Excursion Temperature based on Location (ETL), degrees Celsius. See Subsystem Technical Specification (SSTS) Normal Operating Temperature Section.
Applicability. This test is for the clean air duct assembly of the air induction system. This test is also applicable to the dirty side air duct if required.
Note: Nothing in this standard supercedes applicable laws and regulations.
Note: In the event of conflict between the English and domestic language, the English language shall take precedence.
Purpose. The purpose of this test is to determine how the design of clean air ducts (low pressure side for turbocharger) will react to changes in vacuum caused by slow/steady engine vacuum increase, and sudden/short term vehicle acceleration with a dirty air filter. The test determines a change in the cross section profile of the duct at the Excursion Temperature based on Location (ETL), degrees Celsius. See Subsystem Technical Specification (SSTS) Normal Operating Temperature Section.
Applicability. This test is for the clean air duct assembly of the air induction system. This test is also applicable to the dirty side air duct if required.