Full Description

In a centrally heated home using a warm air furnace or boiler, one technique for saving energy is to exclude or control heat for certain areas. This results in uncomfortable areas of the home. A technique resulting in more overall comfort is to provide a source of supplemental heat to those areas being occupied (at the time) and exclude or lower the overall supply of central heat. The work discussed in this paper was aimed at quantifying the potential energy savings of using gas-fired in-space heaters as supplemental heaters and when using the heaters as the sole source of heat for the home.

Data are presented for gas-fired unvented, vented (radiant), vented (convective), and direct-vent heaters installed in two test homes in Cleveland, OH. One home represented a circa 1950s bungalo with minimal insulation and the other a modern, energy-conserving 1984 condominium. Room-to-room temperature, outdoor temperature, thermostat temperature, energy consumption (both gas and electric), and heater cycles were measured. All heaters were installed strictly according to the manufacturerâs instructions, and with enough capacity to heat the whole house. Two-week-long tests were conducted and compared with results for the central heating system.

Results showed that the in-space heaters used less energy than the central system--about 28% less in the 1950s house and about 34% less in the modem house. Further, less electrical energy was used by the heaters. The in-space heater scheme had a larger room-to-room temperature gradient, and the data collected appear to provide heater sizing information that can be used in the ASHRAE Handbook.

Citation: ASHRAE Transactions, vol. 95, pt. 1, Chicago 1989

Product Details

Published: 1989 Number of Pages: 12File Size: 1 file , 1.8 MB Product Code(s): D-24473